Ski-Doo Tundra Series, Operator'S Manual

Page: 90 / 159

MAINTENANCE PROCEDURES
mmo2010-009-002_a
1. Rubber stop block
2. Bump
3. Feeler gauge
6. Tighten screws to 10 N•m ± 2 N•m
(89 lbf• in ± 18 lbf• in ) following the
illustrated sequence, taking care not
to pinch the feeler gauge.
mmo2010-009-007_b
TIGHTENING SEQUENCE
NOTICE
Serious pulley damage
can occur if the engine stopper and
its screws are not properly installed.
Brake Fluid
Recommended Fluid
Use only DOT 4 brake fluid from a
sealed container. An opened container
may be contaminated or may have ab-
sorbed moisture from the air.
WARNING
Use only DOT 4 brake fluid from a
sealed container. To avoid serious
damage to the braking system, do
not use fluids other than the rec-
ommended one, nor mix different
fluids for topping up.
NOTICE
Brake fluid can damage
painted and plastic parts. Handle
with care. Rinse thoroughly in case
of spillage.
Brake Fluid Level Verification
Place vehicle on a level surface.
Check brake fluid (DOT 4) in reservoir
for proper level. Add fluid (DOT 4) as
required.
mmo2008-008-012_d
TYPICAL
1. Brake fluid reservoir
mmo2008-008-018_a
1. Minimum
2. Maximum
3. Operating range
CAUTION Avoid getting brake
fluid on skin or eyes - it may cause
severe burns. In case of contact
skin, wash thoroughly. In case of
contact with the eyes, immediately
rinse with plenty of water for at least
10 minutes and then consult a doc-
tor immediately.
88
______________