MAINTENANCE PROCEDURES
ENGINE
SPARK PLUG GAP
(NOT ADJUSTABLE)
550F
0.45 mm (.018 in)
2. Apply LOCTITE 767 (ANTISEIZE
LUBRICANT) (P/N 293 800 070) on
spark plug threads.
3. Screw spark plugs into cylinder
head by hand until it bottoms.
4. Perform the final tightening using
the appropriate tools from the tool
kit or with a torque wrench and a
proper socket.
– With a torque wrench (preferred):
tighten
to
27 N•m ± 2 N•m
(20 lbf•ft ± 1 lbf•ft).
– With the socket from the tool
kit: tighten 1/2 turn for a new
spark plug and 1/10 turn for a
used spark plug.
5. Connect spark plug wires.
Spark Plugs (600 ACE and
600 HO E-TEC)
Spark plugs inspection or replacement
must be done by an authorized Ski-Doo
dealer.
Engine Stopper
(600 HO E-TEC)
Engine Stopper Adjustment
The engine stopper is located on the
LH front engine support, in front of the
drive pulley.
1. Remove tether cord cap from en-
gine cut-off switch.
2. Remove drive belt guard, refer to
CONTROLS, INSTRUMENTS AND
EQUIPMENT
in this section.
3. Loosen the three screws retaining
the engine stopper to the engine
support just enough to allow a verti-
cal play (1/2 to one turn).
mmo2010-009-007_a
1. Drive pulley
2. Engine stopper screws
3. Engine stopper
4. Insert a 0.5 mm (.02 in) feeler gauge
in the engine stopper opening (see
illustration).
mmo2010-009-001_a
1. Opening
2. Feeler gauge
5. Place feeler gauge between engine
stopper and rubber stop block (on
engine).
NOTE:
Do not insert the feeler gauge
too deep, as it will pass over the bump
at the surface of the rubber stop block
and alter adjustment. See illustration.
_______________
87
Summary of Contents for Tundra Series
