Ski-Doo Tundra Series, Operator'S Manual

Page: 100 / 159

MAINTENANCE PROCEDURES
mmr2008-048-008_a
1. RH rear idler wheel bolt
4. Tighten or loosen both adjustment
screws to increase or decrease
track tension.
mmr2008-048-009_a
1. RH adjustment screw
5. If correct tension is unattainable,
contact an authorized Ski-Doo
dealer.
6. Retighten retaining bolts to specifi-
cation..
TORQUE
Retaining
bolts
48 N•m ± 6 N•m
(35 lbf•ft ± 4 lbf•ft)
7. Check track alignment as described
below.
Track Alignment
WARNING
Before checking track alignment,
ensure that the track is free of all
particles which could be thrown
out while track is rotating. Keep
hands, tools, feet and clothing
clear of track. Always lift the snow-
mobile on a wide-base stand with
a rear deflector panel. Ensure no
one is standing in close proximity
to the snowmobile, especially at
the rear of the track. Never rotate
track at high speed.
Centrifugal force could cause de-
bris, damaged or loose studs,
pieces of torn track, or an en-
tire severed track to be violently
thrown backwards out of the tun-
nel with tremendous force.
1. Lift rear of vehicle and support it off
the ground.
CAUTION Use proper lifting
techniques, notably using your legs
force. Do not attempt to lift the rear
of vehicle if it is above your limits.
2. Start engine and accelerate slightly
so that track slowly turns. This must
be done in a short period of time (15
to 20 seconds).
3. Check that the track is well cen-
tered; equal distance on both sides
between edges of track guides and
slider shoes.
A01F05A
1
2
3
1. Guides
2. Slider shoes
3. Equal distance
98
______________