Ski-Doo Skandic Series 2016, Operator'S Manual

Page: 93 / 163

MAINTENANCE PROCEDURES
2. Insert the DRIVEN PULLEY OPEN-
ING TOOL (P/N 529 017 200) (or the
pulley expander provided in the tool
box) in the threaded hole on the ad-
juster hub.
529017200
DRIVEN PULLEY OPENING TOOL
mmo2012-005-980
PULLEY EXPANDER INSTALLED ON
ADJUSTER HUB
3. Open the driven pulley by screwing
the tool in.
4. To remove belt, slip the belt over the
top of driven pulley, then over the
drive pulley.
Drive Belt Installation
1. If necessary, open the driven pul-
ley, refer to
DRIVE BELT REMOVAL
above.
2. Slip the drive belt over the drive pul-
ley, then over the driven pulley.
NOTICE
Do not force or use tools
to pry the drive belt into place, as
this could cut or break the cords in
the drive belt.
NOTE: The maximum drive belt life
span is obtained when drive belt is in-
stalled with arrows in the direction of
rotation.
mmo2011-002-006_a
1. To be pointed in the direction of rotation
3. Unscrew and remove the driven pul-
ley expander from the pulley.
4. Rotate the driven pulley several
times to properly set the drive belt
between the sheaves.
5. If a new drive belt was installed,
adjust the drive belt height. Refer
to
DRIVE BELT HEIGHT ADJUST-
MENT
below.
6. Install drive belt guard and close
side panel. Refer to CONTROLS,
INSTRUMENTS AND EQUIPMENT
.
Drive Belt Height Adjustment
The drive belt height must be checked
every time a new drive belt is installed.
To adjust the drive belt height, proceed
as follows:
1. Remove tether cord cap from en-
gine cut-off switch.
2. Remove drive belt guard.
3. Loosen the clamping bolt.
_______________
91