Ski-Doo Skandic Series 2016, Operator'S Manual

Page: 47 / 163

CONTROLS, INSTRUMENTS AND EQUIPMENT
550F Models
mmo2007-003-003_c
TYPICAL
1. Heated throttle lever switch
2. Hot
3. Warm
4. Off
Mode/Set Button
E-TEC and ACE
This button can be used instead of the
two buttons on top of the analog/digital
gauge to facilitate gauge adjustments.
– When pressed left, it has the same
functions as the MODE (M) button.
– When pressed right, it has the same
functions as the SET (S) button.
mmo2014-004-001_f
MULTIFUNCTION GAUGE
1. MODE function
2. SET function
8) Gearshift Lever
Use this lever to select gears. The
gearbox has two forward gears, a re-
verse gear and a neutral.
Refer to
GEARBOX OPERATION
in
OPERATING INSTRUCTIONS
for de-
tails.
NOTE: It is necessary to push shift
lever knob down to move it from neu-
tral to reverse gear.
9) Adjustable Mirrors
Each mirror can be adjusted to suit
driver's preference by gently rotating
the mirror glass.
WARNING
Adjust with vehicle at rest in a safe
place.
10) Tool Kit
A tool kit containing tools for basic
maintenance is supplied with the vehi-
cle.
The tool kit support is located in engine
compartment on pulley guard.
NOTICE
Make sure tool kit is se-
cured properly to avoid contact with
drive belt or drive pulley.
To remove the tool kit support from
the pulley guard, unlock the tab from
underneath the pulley guard and pull
the tool kit support towards front to
release it.
mmo2008-003-061_a
TYPICAL
1. Tool kit
_______________
45