71
Shutting Off the Engine
Release throttle lever and wait until engine has returned to idle speed.
Shut off the engine using either ignition switch, engine cut-out switch
or tether cut-out switch.
VEHICLE WARM-UP
Before every ride, vehicle has to be warmed up as follows.
Snowmobile must be securely supported by the rear bumper using
a mechanical snowmobile stand. Track must be 100 mm (4 in) off the
ground.
Start engine and allow it to warm up two or three minutes at idle speed.
NOTE:
The Skandic WT/SWT/WT LC gearbox may be in neutral posi-
tion.
Release parking brake.
Apply throttle until drive pulley engages. Let track rotate at low speed
for several turns. The lower the vehicle temperature is the longer
vehicle warm-up should be.
Shut-off the engine and remove the snowmobile mechanical stand.
Skis may be frozen on the ground. Grasp both skis by their loops and
lift them.
After restarting engine, the vehicle can be driven at low speed for the
first 2 or 3 minutes. After that, it may be driven up to the legal speed
limit as per normal safety practices.
WARNING
Never leave key and tether cord on vehicle when not in oper-
ation.
WARNING
Make sure mechanical snowmobile stand is stable. Stay clear
of the front of vehicle and the track. Do not use too much throt-
tle during warm-up or when track is free-hanging.
Mmo2002-001a.book Page 71 Friday, January 12, 2001 1:56 PM
Summary of Contents for Skandic LT 2002
