104
All Models
Check that the air silencer is clean and dry and properly reinstall the
filter.
CAUTION:
Snowmobile engines have been calibrated with the
filter installed. Operating the snowmobile without it may cause
engine damage.
Bulb Replacement
Always check light operation after bulb replacement.
Headlight
CAUTION:
On applicable models, never touch glass portion of an
halogen bulb with bare fingers, it shortens its operating life. If
glass is touched, clean it with isopropyl alcohol which will not
leave a film on the bulb.
Tundra R
If headlamp is burnt, tilt hood. Unplug connector from headlamp. Re-
move protector cap and unfasten bulb retainer clips. Detach bulb and
replace.
TYPICAL
1. Retainers clips
1
A02E09A
Mmo2002-001a.book Page 104 Friday, January 12, 2001 1:56 PM
Summary of Contents for Skandic LT 2002
