65
Starting the Engine
Before Starting
• Re-check throttle control lever operation.
• Ensure that the engine cut-out switch is in the ON position.
• Ensure the tether cut-out cap is in position and that the cord is
attached to your clothing.
Primer Equipped Vehicles
• To prime, activate button until a pumping resistance is felt. From
this point, pump 2 or 3 times to inject fuel in intake manifold. After
priming, ensure that primer button is pushed back.
NOTE:
In very cold temperature, it is recommended to rotate primer
button 3 - 4 turns prior to pull it. This will eliminate the possibility of
sticking.
NOTE:
Priming is not necessary when engine is warm.
Choke Equipped Vehicles
0. OFF
1. Position 1
2. Position 2
WARNING
Operator and passenger (if applicable) must be properly seat-
ed before starting engine.
0
1
2
A06H1KB
Mmo2002-001a.book Page 65 Friday, January 12, 2001 1:56 PM
Summary of Contents for Skandic LT 2002
