62
PRE-OPERATION CHECK
• Verify track and idler wheels are unfrozen and free to turn.
• Activate the brake control lever and make sure the brake fully ap-
plies before the brake control lever touches the handlebar grip. It
must fully return when released.
• Check the parking device. Apply parking brake and check if it oper-
ates properly.
• Activate the throttle control lever several times to check that it
operates easily and smoothly.
• Check operation of ignition switch, headlight switch (HI-LO), taillight,
brake light, indicator lights and tether and engine cut-out switches.
• Check gear shift lever position (models with mechanical reverse only).
• Verify that skis and steering operate freely. Check corresponding
action skis versus handlebar.
• Check fuel and injection oil for levels and leaks. Replenish as nec-
essary and see an authorized SKI-DOO dealer in case of any leaks.
• Verify that air filter(s) is free of snow, if so equipped.
• All storage compartments must be properly latched and they must
not contain any heavy or breakable objects.
WARNING
The pre-operation check is very important prior to operating the
vehicle. Always check the proper operation of critical controls,
safety features and mechanical components before starting. If
not done as specified here, severe injury or death might occur.
WARNING
Always use a mechanical snowmobile stand to properly support
vehicle during any track verification. Slowly accelerate engine in
order to rotate track at very low speed when it is not on ground.
WARNING
Throttle lever must operate easily and smoothly. It must re-
turn to idle position when released.
WARNING
All adjustable features should be positioned at optimal setting.
Securely tighten all adjustment locks.
Mmo2002-001a.book Page 62 Friday, January 12, 2001 1:56 PM
Summary of Contents for Skandic LT 2002
