95
Track Condition
Lift the rear of the snowmobile and support it off the ground. With
the engine off, rotate the track by hand, and inspect condition. If worn
or cut, or if track fibers are exposed, or if missing or defective inserts
or guides are noted; contact an authorized SKI-DOO dealer.
CAUTION:
Do not modify track, including by installing traction
enhancing products. This may weaken the track and cause it to
break without warning.
Track Tension and Alignment
Tension
NOTE:
Ride the snowmobile in snow about 15 to 20 minutes prior to
adjusting track tension.
Lift rear of snowmobile and support it with a
snowmobile mechan-
ical stand
.
Allow the suspension to extend normally and check gap half-way
along slider shoe. The gap should be as mentioned in SPECIFICA-
TIONS at the end of this guide. If the track tension is too loose, track
will have a tendency to thump.
NOTE:
A belt tension tester (P/N 414 348 200) may be used to mea-
sure deflection as well as force applied.
1. Belt tension tester
WARNING
Do not operate or rotate a track if torn, damaged or excessively
worn (fiber showing).
A00C07A
1
Mmo2002-001a.book Page 95 Friday, January 12, 2001 1:56 PM
Summary of Contents for Skandic LT 2002
