86
Skandic WT/SWT/WT LC
1. Turn off engine cut-out switch.
2. Open hood. Remove both retaining pins then belt guard.
TYPICAL
1. Retaining pins
All Models
When reinstalling belt guard, position its cut-away toward front of
snowmobile. Refer to decal on belt guard.
NOTE:
Belt guards are purposely made slightly oversize to maintain
tension on their pins and retainers preventing undue noise and vibra-
tion. It is important that this tension be maintained when reinstalling.
Drive Belt Removal/Installation
Removal
All Models
NOTE:
Removal and installation of drive belt is easier when driven
pulley is held with brake so that it can not rotate. Apply parking brake,
for this purpose.
Turn off engine cut-out switch. Open hood and remove belt guard.
A29D0FA
1
Mmo2002-001a.book Page 86 Friday, January 12, 2001 1:56 PM
Summary of Contents for Skandic LT 2002
