Ski-Doo FORMULA S 1997, Shop Manual

Page: 842 / 926

Section 08 BODY/FRAME
Sub-Section 02 (BODY)
08-02-2
DECAL
To remove a decal; heat old decal with a heat gun
and peel off slowly.
Using isopropyl alcohol, clean the surface and dry
thoroughly.
Apply liquid soap to new decal and carefully posi-
tion the decal. Using a sponge or a squeegee, re-
move the air bubbles and surplus water working
from the center toward the edges. Allow to air
dry.
WINDSHIELD INSTALLATION
When peeling off the protective film some poly-
ethylene particles may remain on the windshield.
A soft clean cloth moistened with naphtha (camp-
ing equipment fuel) will easily remove the remain-
ing particles.
Position the windshield on the hood then push it
down until the tabs are fully inserted into the hood
slots. Lock the windshield tabs in position.
HOOD
F Series
Unfasten speedometer cable, wiring harnesses
then retaining cables.
Unbolt front molding and unclip it.
Close hood.
Remove molding.
Remove hinge pin.
At installation, half close hood to install front
molding.
BELT GUARD
Disassembly and Assembly
NOTE: For additional information (ex.: exploded
view) refer to the correspondent parts catalog.
Inspection
Check belt guard and/or pulley guard mounting
bosses, clips and retainers for wear.
WIRING HARNESS
-
CAUTION
Do not apply isopropyl alcohol or solvent di-
rectly on decals.
◆
WARNING
Naphtha is flammable and explosive under
certain conditions. Always manipulate in a
well ventilated area. Do not smoke or allow
open flames or sparks in the vicinity.
◆
WARNING
Engine should be running only with belt
guard and/or pulley guard well secured in
place.
◆
WARNING
Ensure all terminals are properly crimped on
the wires and that all connector housings
are properly fastened. Keep wires away
from any rotating, moving, heating and vi-
brating parts. Use proper fastening devices
as required.
A06H1NA
1
2