Ski-Doo FORMULA S 1997, Shop Manual

Page: 653 / 926

IX
05-03-5
A16D0IA
1
2
A
1
Turn puller handle and sliding half at once to extract
the bushing.
INSTALLATION
Countershaft
F-Series and S-Series Only
Should installation procedure be required, refer
to BRAKE 05-05 then look for
Brake Disc and
Countershaft Bearing Adjustment .
IMPORTANT: Large bushing retaining screws and
washers must be removed before small bushing
installation.
Coat bushing outside diameter with Loctite 609
(P/N 413 7031 00).
Install bushing as following photo.
Always apply anti-seize lubricant (P/N 413 7010
00) on the countershaft before final pulley
installation.
All Models
Check end play of driven pulley on countershaft by
pushing pulley towards outer housing so that the inner
shims ( P/N 504 1082 00) contact it. Measure end play
at the mounting screw end between shim(s) and puley.
See illustration.
TYPICAL — TOP VIEW
1. Shim (P/N 504 1082 00) (as required)
2.Contact
A. 0 to 1 mm (0 to 3/64 in)
Torque retaining screw no. 13 to 25 N•m (18 lbf•ft).
ADJUSTMENT
Refer to PULLEY DISTANCE AND ALIGNMENT 05-04
to adjust pulley distance. Adjust drive belt height
between pulley halves to obtain specified belt
deflection.
Reinstall the pulley on the countershaft by rever-
sing the removal procedure.
A03D1YA
529 0313 00
529 0312 00
A03D1ZA
529 0313 00
529 0312 00
Cam
Coat cam no. 18 interior with anti-seize lubricant.
ASSEMBLY
Came Slider Shoe
Section 05 TRANSMISSION
Sub-Section 03 (DRIVEN PULLEY)
When replacing slider shoes no. 4 , always install a new
set (3 shoes) to maintain equal pressure on the cam.
Assemble driven pulley components by reversing
the disassembly procedure.
TYPICAL PAGE
Title indicates
main procedure
to be carried-out.
Reference to look up
a certain section and
sub-section (PULLEY
DISTANCE AND
ALIGNMENT 05-04).
In this case it concerns
pulleys adjustment.
Italic bold face setting
in this case indicates
that particular
procedure for
F and S-series is
finished, so from
this point, all models
are concerned.
Illustration always
follows text to which
it pertains.
A01A1RS
Sub-title indicates
a particular procedure
for the named part.
Number: Following part name
refers to exploded view
at beginning of sub-section.
Call-outs for
above illustration.
Italic bold face type
setting indicates a
particular procedure
concerning a model.
"TYPICAL" caption
indicates a general
view which does
not represent full
detail.
"TOP VIEW"
caption helps you
in understanding
illustration.
CAUTION
▼
1997 BOMBARDIER SNOWMOBILES
SHOP MANUAL