Ski-Doo FORMULA S 1997, Shop Manual

Page: 733 / 926

Section 03 ENGINE
Sub-Section 07 (REWIND STARTER)
03-07-3
1. Grease inside spring guide
To install a new rope no. 6 : insert rope into
sheave no. 5 orifice and lock it with the key no. 7
as illustrated.
1. Push to lock
To adjust rope tension:
Wind rope on sheave and place rope sheave into
starter housing making sure that the sheave hub
notch engages in the rewind spring hook.
Rotate the sheave counterclockwise until rope
end is accessible through starter housing orifice.
Pull the rope out of the starter housing and tem-
porarily make a knot to hold it. One turn preload
will give 7 turns of tension when fully extended.
Position pawl no. 8 , pawl lock no. 9 and circlip
no. 10 .
Install locking spring no. 11 and lubricate with
MOLYKOTE G-n paste from Dow Corning ® or
equivalent.
1. Spring coated with MOLYKOTE G-n paste
Install locking ring.
-
CAUTION
The use of standard multi-purpose grease
could result in rewind starter malfunction.
A01C14A
1
A01C15A
1
-
CAUTION
This lubricant must NOT be used on rewind
springs as it does not stay on when dry.
A01C0CA
A01C17A
1