Ski-Doo FORMULA S 1997, Shop Manual

Page: 162 / 926

Section 04 TRANSMISSION
Sub-Section 06 (BRAKE)
04-06-8
Install a hose on left side bleeder. Route this hose
to a container.
Pump a few times brake lever and while holding
brake lever depressed, open bleeder and check
for air to escape.
Repeat with the same bleeder until no air appears
in hose.
Proceed the same way with the right side bleeder.
1. Open bleeder
2. Clear hose to catch used brake fluid
Brake Light
Models with Mechanical Brake
Except Tundra II LT
Brake light should light up before brake pads
touch brake disc. To adjust, unscrew nut
no. 10
until brake light goes on.
WARNING : At least one full thread must
exceed the elastic stop nut.
Check brake adjustment as described above.
NOTE : If brake light adjustment is unattain-
able while respecting brake adjustment,
ratchet wheel may be too far out. If so, tighten
ratchet wheel.
Tundra II LT
Brake light should light up before brake pads
touch brake disc. To adjust, unlock nut
no. 21 and
turn brake switch no. 22 accordingly. Lock in po-
sition by tightening nut no. 21 .
Models with Hydraulic Brake
There is no adjustment on these models. Check
that switch is securely installed.
A06D0JA
2
1
;
'