Super Shot Deluxe
Assembly and Operating Manual
Page 10 of 52
4. Locate the two cables and one ground strap on the Backboard Assembly. Connect the two Hoop Sensor cables to
the connectors mounted at the rear of the game and marked “Upper Sensor” and “Lower Sensor”. Make sure the
upper Hoop Sensor cable is connected to the Upper Sensor connector, and likewise with the Lower Hoop Sensor
cable. Lastly, attach the ground strap to the rear frame at the point indicated by the decal using the hex head
screw pre-attached at the point.
5.
Failure to attach the ground strap could cause damage to the Motor Control Board.
6. Install the Crowd Panel by plugging it into the tubes at the rear of the Read Assembly.
7. Install the Ball Guard so that the plastic is on the inside of the game and the bend is pointing towards the
Backboard Assembly.
8. Locate the Left and Right Side Netting Panels labeled accordingly. The labels are located towards the front of
each piece. Position each panel and secure using ¼ -20 x 1” long button head Allen bolts. .
9. Place the Canopy on top of the game. Affix in the front first and use ¼ -20 x 1” long button head bolts and nyloc
nuts in all locations.
10. Cut the tywrap holding the Cable Assemblies at the center of the game below the Scoreboard. Route the cables
toward the front of the game by pushing them into the wire saddles located on the sides of the tubing under the
left side of the Front Assembly.
11. Locate and plug in the white 15 position cable. This cable supplies AC power and DC signals for the Motor
Control Circuit at the rear of the game as well as DC power and signals to the hoop sensors.
12. Locate and plug in the white 4 position cable. This cable supplies 24 Volts AC to the Scoreboard.
