THERMAL RECEIPT PRINTER
36
①
ESC @
is executed.
②
ESC &
is executed.
③
FS q
is executed.
④
Printer is reset or the power is turned off.
• The following figure shows the relationship between the downloaded bit image
and the printed data.
[Reference]
GS /
GS /
m
[Name] Print downloaded bit image
[Format] ASCII GS /
m
Hex 1D 2F
m
Decimal 29 47
m
[Range]
0
≤
m
≤
3, 48
≤
m
≤
51
[Description] Prints a downloaded bit image using the mode specified by
m
.
m
selects a mode from the table below:
m
Mode
Vertical Dot Density (DPI)
Horizontal Dot Density (DPI)
0, 48
Normal
200
200
1, 49
Double-width
200
100
2, 50
Double-height
100
200
3, 51
Quadruple
100
100
[Details] • This command is ignored if a downloaded bit image has not been defined.
• In standard mode, this command is effective only when there is no data in the
print buffer.
• This command has no effect in the print modes (emphasized, double-strike,
underline, character size, or white/black reverse printing), except forupsidedownprinting mode.
• If the downloaded bit-image to be printed exceeds the printable area, the
excess data is not printed.
• Refer to Figure 3.12.3 for the downloaded bit image development position in
page mode.
• If the printing area width set by
GS L
and
GS W
is less than one line in vertical,
the following processing is performed only on the line in question:
①
The printing area width is extended to the right up to one line in vertical. In
this case, printing does not exceed the printable area.