THERMAL RECEIPT PRINTER
25
Use the horizontal motion unit ( x) for setting the horizontal starting position and
printing area width, and use the vertical motion unit ( y) for setting the vertical
starting position and printing area height.
When the horizontal starting position , vertical starting position, printing area
width, and printing area height are defined as X, Y, Dx, and Dy respectively, the
printing area is set as shown in the figure below.
This printable area for this printer is approximately 72 mm in the horizontal
direction and approximately 117.3 mm (1662/360 inches) in the vertical direction.
[Default] xL = xH = yL = yH = 0
dxL = 0, dxH = 2, dyL = 126, dyH = 6
[Reference]
CAN
,
ESC L
,
ESC T
,
GS P
ESC \
nL nH
[Name] Set relative print position
[Format] ASCII ESC \
nL nH
Hex 1B 5C
nL nH
Decimal 27 92
nL nH
[Range] 0
≤
nL
≤
255
0
≤
nH
≤
255
[Description] Sets the print starting position based on the current position by using the
horizontal or vertical motion unit.
• This command sets the distance from the current position to [(
nL + nH
╳
256)
╳
horizontal or vertical motion unit]
[Details] • Any setting that exceeds the printable area is ignored.
• When pitch N is specified to the right:
nL+ nH
╳
256
= N
When pitch N is specified to the left (the negative direction), use the
complement of 65536.
When pitch N is specified to the left:
nL+ nH
╳
256
=
65536
- N
• The print starting position moves from the current position to [ N
╳
horizontal or
vertical motion unit]