Sinclair SMH-100IRA? SMH-140IRA, Control And Operation Manual

Page: 18 / 36

14
[Notes]
(a) When “ Clock timer ” has already been set and the concerned modes include “ Hot water ”, if resetting “ Water
tank
” from “
With
” to “
Without
”, then “
Hot water
” mode will be automatically changed to “
Heat
”, “
Cool+hot
water ”/ “ Heat+hot water ” changed to “ Cool ”/ “ Heat ”.
(b) When “ Weekly timer ” and “ Clock timer ” settings are performed at the same time, the latter takes
precedence.
(c) When the water tank is available, the allowed running modes include “
Heat ”, “ Cool ”, “ Heat+ hot water ”,
“ Cool+hot water ”, and “ Hot water ”. When the water tank is unavailable, the allowed running modes only
include “
Heat
” and “
Cool
”.
(d) This setting is the same as that of note (b) in " Weekly timer ".
(e) Instructions for " Hot water " under " Clock timer " is the same as that of note (c) in " Weekly timer ".
2.2.14 Temp. Timer
This function will make the unit run with certain temperature in a certain period within a day based on the user’s
actual demand.
[Operation Instructions]
(1) At the homepage, by pressing the Function key access to the FUNCTION page, and then locate
where “ Temp timer ” is, after that, press OK key to go to the TEMP TIMER setting page.
(2) At the
TEMP TIMER
setting page, by the Left/Right key select the desired parameter and then
by the Up/Down key configure it. The configurable parameters include “ Mode ”, “ Period 1 ”, “ WT-
HEAT 1 ”, “ Period 2 ” and “ WT-HEAT 2 ”.
(3) When the setting is finished, save it by pressing the Function key no. 2 , or this setting without being
saved is ineffective.
(4) When the setting has been saved, activate the “ Temp. timer ” at the FUNCTION page.
[Notes]
(a) When “ Weekly timer ”, “ Clock timer ”, and “ Temp. timer ” settings are performed at the same time, the last
one takes precedence.
(b) This function works only when the unit is in operation.
(c) The allowed running modes include “
Heat ” and “ Cool ”
(d) When the start time of “ Period 2 ” is equal to that of “ Period 1 ”, then the set point of “ Period 2 ” takes
precedence.
(e)
TEMP. TIMER is judged by the timer value.
(f) During the setting, the temperature set point which is set manually always takes precedence.