Sinclair SMH-100IRA? SMH-140IRA, Control And Operation Manual

Page: 16 / 36

12
(4) When above settings are finished, pressing the Return key and then pressing “ Save ”, a pop-up window will
pop up to remind if you are determined to save these settings. If so, press the OK key . If not, press
the Return key to not save these settings.
(5) In this case, finally by pressing the Up key , “
Weekly timer
” will be activated.
[Notes]
(a) Totally five periods are allowed to be set for each time. For each period, “ Start time ” must be earlier than
“
End time
”. Similarly, the preceding period must be earlier than its following period.
(b) When “ Weekly timer ” has been set successfully, by changing “ Water tank ”, “ Ctrl state ”, or “ T-water ctrl ”,
then the temperature set point for “ Weekly time r” will be automatically changed to the corresponding default.
For instance, if “ Heat ” is set for Monday of “ Weekly timer ”, “ Ctrl state ” is set to " High temp " and “ T-water
out ” is set to 59
℃ ,
then by resetting “ Ctrl state ” to “ Normal temp ”, then “ T-water out ” will be the default value
(35 ).
(c) When “
Weekly timer
” has been set successfully, water heating, solar heater or water tank heater is
available and water temperature set point is higher than 50
，
at this time if stopping the solar heater or water
tank heater (including the solar timer is timed to be off), then water tank tempeature will be always kept at 50 .
(d) At the “
WEEKLY TIMER ” setting page there are totally three setting types for each day
•
“√”: it indicates once the Week Timer is activated, the timer on this day is effective and will not be
affected by the “ Holiday ” mode.
•
“×”: it indicates even if the Week Timer is activated, the timer on this day is ineffective.
•
“ Holiday ”: it indicates when the Week Timer is activated but “ Holiday ” is not activated, then the timer on
this day is effective; when “Holiday” is also activated, the timer on this day is ineffective.
(e) When “ Weekly timer ” has already been set and the concerned modes include “ Hot water ”, if resetting
“ Water tank ” from “ With ” to “ Without ”, then “ Hot water ” mode will be automatically changed to “ Heat ”,
“ Cool+hot water ”/ “ Heat+hot water ” changed to “ Cool ”/ “ Heat ”.