Sinclair SMH-100IRA? SMH-140IRA, Control And Operation Manual

Page: 30 / 36

26
16 Swimming pool-leaving water temp T-Swimming out
17 Discharge pressure Dis.pressure
18 Enthalpy-enhancing pressure En.pressure
19 Suction pressure Su.pressure
20 Target temperature for Weather-dependent Mode T-auto mode
21 Target temperature for floor debug T-floor debug
22 Time period for floor debug Debug time
2.4.3 Error View
At the error view pages, the user is enabled to see which error the unit suffers.
[Operation Instructions]
(1) At the
VIEW
page, select
Error
and then press the OK key to go to the
ERROR
page.
(2) At the
Error View
page, it is able to view each error.
[Notes]
(a) The real-time error will show on the control. Taking Error 2 in the above figure for example, when it is
recovered, it will disappear and be replaced by Error 3, and other errors follow the same way.
(b) If the total no. of errors exceed six, other errors should be viewed by switching pages through “ Last ”
and “ Next ” .
(c) Any one among “ IDU auxiliary heater 1 error ”, “ IDU auxiliary heater 2 error ”, “ Water tank heater error ”
occurs, the control will beep until this error has been cleared.
(d) See the following table for error description.
No. Full Name Displayed Name Error Code
1 Ambient temperature sensor error Ambient sensor F4
2 Defrost temperature sensor error Defro. sensor d6
3 Discharge temperature sensor error Disch. sensor F7
4 Suction temperature sensor error Suction sensor F5
5 Outdoor fan error Outdoor fan EF
6 Compressor internal overload protection Comp. overload H3
7 High pressure protection High pressure E1
8 Low pressure protection Low pressure E3
9 High discharge protection Hi-discharge E4
10 Refrigerant loss protection Refri-loss P2
11 Heat pump-water pump protection HP-pump E0
12 Solar kit-water pump protection SL-pump EL