Sinclair SMH-100IRA? SMH-140IRA, Control And Operation Manual

Page: 13 / 36

9
[Operation Instructions]
Go to the
FUNCTION
page and locate “
Quiet
”, then, configure it through the Up/Down key , “
On
”
or “
Off
”.
[Notes]
(a) It can be set to “ On ” or “ Off ” no matter if the unit is in operation or not, but this function works only when
the unit is turned on.
(b) Once it is activated, it should be deactivated manually or by
Quiet Timer .
(c) This setting will be memorized upon power failure.
(d) It will be deactivated when the unit is turned off.
2.2.8 Quiet Timer
When running noise is too high at some specific timer period, this function enables the unit run quietly at this
time period.
[Operation Instructions]
(1) Go to the
FUNCTION
page and locate
Quiet timer
, then, access to the
QUIET TIMER
setting page.
(2) At the QUIET TIMER setting page, select “ Start time ” or “ End time ” through the Left/Right keys
and then configure the desired time through the Up/Down keys .
(3) When the mode setting is finished, then by pressing “Save”, a pop-up window will pop up to remind if you
are determined to save this setting. If so, press the “OK” key . If not, press the “Cancel” key to
not save this setting.
(4) When the setting is saved, the control then will back to the FUNCTION page and the cursor will be where
the “ Quiet timer ” option is, then by the Up/Down key , it can be set to be “ On ” or “ Off ”.
[Notes]
(a) Once it is activated, it should be deactivated manually.
(b) This setting will be memorized upon power failure.
(c) The saved “
Start time ” and “ End time ” will be memorized upon power failure.
(d) It is configurable no matter if the unit is in operation or not.
2.2.9 Weather-dependent Mode
For areas with large change of diurnal temperature, in order to avoid the user to set the leaving water
temperature or room temperature too often, this function will adjust automatically depending on the environmental
temperature.
[Operation Instructions]
Go to the FUNCTION page and locate Weatherdepend , then, configure it through the Up/Down key
, “ On ” or “ Off ”.
[Notes]
(a) Once it is activated, it should be deactivated manually.
(b) This setting will be memorized upon power failure.