Sinclair SMH-100IRA? SMH-140IRA, Control And Operation Manual

Page: 23 / 36

19
[Operation Instructions]
(1) When the water tank is avaiable, this option is configurable. At the setting page, it can be set to "With" or
"Without".
(2) When the water tank is unavailable, this option is reserved and unconfigurable.
[Notes]
It will be memorized upon power failure.
2.2.24 Plate heater
The plate heater can be activated or deactivated by the user. Generally it is suggested to activate it when the
water pump has stopped and the environment temperature is lower than 2°C so as to prevent the heat exchanger
from being frozen.
[Operation Instructions]
Go to the FUNCTION page and locate “ Plate heater ” then, configure it through the Up/Down key ,
“ On ” or “ Off ”.
[Notes]
It will be memorized upon power failure.
2.2.25 Solar antifre
When the solar system has been installed, it is highly suggested to activate this function.
[Operation Instructions]
Go to the FUNCTION page and locate “ Solar antifre ” then, configure it through the Up/Down key ,
“ On ” or “ Off ”.
[Notes]
It will be memorized upon power failure.
2.2.26 Water Tank
It can be configured to be “ With ” or “ Without ” based on the actual condition.
[Operation Instructions]
Go to the FUNCTION page and locate “ Water tank ” then, configure it through the Up/Down key ,
“ With ” or “ Without ”.
[Notes]
(a) It will be memorized upon power failure.
(b) This setting is allowed only when the unit is turned off.
2.2.27 Tank Sensor
When the water tank has been installed, one group or two groups of tank sensors can be selected to detect and
control the water tank temperature.
[Operation Instructions]
Go to the FUNCTION page and locate “ Water tank ”, then, configure it through the Up/Down key , “ 1 ”
or “
2
”. When the water tank is unavailable, this option will be reserved.
[Notes]
It will be memorized upon power failure.
2.2.28 Solar Heater
It can be configured to be “ With ” or “ Without ” based on the actual condition.
[Operation Instructions]
Go to the FUNCTION page and locate “ Solar heater ”, then, configure it through the Up/Down key ,
“ With ” or “ Without ”.
[Notes]
It will be memorized upon power failure.
2.2.29 Floor config
It can be configured to be “With” or “Without” based on the actual condition.
[Operation Instructions]