Simplex 4100U-S1, Operator'S Manual

Page: 14 / 86

1-4
Table 1-1. Components of the Operator Interface ( continue d)
LED/Key Description Refer To
SYSTEM WARNINGS The System Warning LEDs –
Isolation and Fault – indicate when
abnormal, non-fire conditions occur.
Chapter 3
Isolate LED and Ack Key
When any zone is isolated, this LED
turns on and the buzzer sounds until
Isolate Ack is pressed.
Chapter 3
Fault LED and Ack Key
When any fault occurs this LED turns
on and the buzzer sounds until Fault
Ack is pressed.
Chapter 3
Alarm Silenced LED/Alarm
Silence Key
Not normally used in Australia
N/A
AC Power LED
Indicates the presence of AC power
at the panel.
N/A
System Reset Key
Pressing this key directs the panel to
reset all attached devices and clear
all acknowledged alarms, faults, and
isolation conditions.
Chapter 2
Event Time Key
Used to display the time at which an
acknowledged alarm, fault, or
isolation condition occurred.
Chapter 2
Entry Keypad
Used to call up points for monitoring
and control.
Chapter 5
Enable & Disable Keys
Pressing these keys allows you to
enable or disable devices attached to
the panel.
Chapter 4
On/Off/Auto Keys
Pressing these keys allows you to
force a device (such as a relay) ON
or OFF. The Auto key returns
control of the device to the panel.
Chapter 4
Arm & Disarm Keys
Used with security points. These
keys allow you to turn security
devices on (arm) or off (disarm).
N/A
More Info.
Used in some options to request
information.
Chapter 9
Lamp Test
Pressing this turns on all LEDs to
show that they operate.
Chapter 9
Menu / Next / Previous /
< / >
Press the Menu key to display the
menu options on the LCD. Next &
Previous allow stepping through
options/events, < & > allow cursor
movement in the LCD.
Chapter 5 on
Continued on next page
Basic System Description,
Continued
Overview,
( continued )