18
Neutro-Vac
5200470 Rev B
WARNING
– Do not hang rags on static bar or a fire may result.
5. Clean points using a stiff nylon brush.
Accessory Mounting
If it becomes necessary to remove the static bar, air bar, or brush for service, be sure
to replace it in the correct location relative to the web.
1. The MEB or IQ Easy Static Bar must be mounted with its points facing the web
and centered between mounting brackets. Secure the static bar with set screws
in the mounting bracket.
2. When replacing the air bar, holes must be pointed directly at the web
perpendicular to its surface). Secure the air bar with set screws in mounting
brackets.
Dust Collector Maintenance
WARNING
– Disconnect and lockout power to the Neutro-Vac Web
Cleaning System before performing all maintenance procedures unless
otherwise instructed. Turn off web drive equipment and remove web (if
possible) before performing maintenance.
All Models
1. Empty collector drawer or drum when approximately two-thirds full.
2. Remove any dust settled at the bottom of the dust compartment on a weekly
basis.
3. Follow the manufacturer’s directions for motor maintenance. If your motor
requires servicing under the manufacturer’s warranty, contact an authorized
service center.
