SVD 800 HD
5
ENGLISHENGLISHENGLISHENGLISHENGLISH
- If the projector is not used for long periods of time or
during storms, unplug the projector temporarily from the
mains to avoid damaging the projector caused by
lightning or temporary overcurrents.
- Do not stand the projector on unstable surfaces as it
could drop causing serious damage.
- The projector has slots for ventilating the internal
components - do not cover or block them.
- The projector should always be put on a solid, firm
surface.
- The projector should not be made part of a fitted
installation or closed unless there is sufficient ventilation.
- After technical assistance or repairs on the projector
have been completed, ask the technician to carry out a
safety check (all cables and components in the right
position) and to make sure the projector is in proper
operating conditions.
2.2 Power cabling
The projector’s mains power device is shown in the picture
Fig. 2.
The projector operates at the following mains values:
120-240Vac 50/60Hz 500W 4.2A RMS-MAX, as
specified on the rear label.
The type of fuse used is a 10A, type T (delay).H (High
breaking capacity)
Warning
The projector must be earthed.
If the power socket is not equipped with an earth pin, call
your electrician who will install it and ensure its efficiency.
To disconnect the cable pull it out with the plug. Do not
pull the cable itself.
If you use an extension lead, make sure its rating is over
5A and is equipped with an earth wire.
Fig. 2
IMPUTS
INFO
-
+
LINE INPUT
•
VEDE
2.3 Servicing
Servicing must be carried out by qualified technicians.
Do not attempt to service the projector without the proper
technical knowledge. Opening the projector can expose
personnel to potential hazards: high voltage and electric
shock.
Unplug the mains cable and call for qualified service
technicians in the following cases:
- when the power cable or plug is damaged
- when liquids, like rain or water, have got inside the
projector
- when the projector is not working properly regardless
of the fact the instructions for use have been followed
correctly
- when the projector has fallen and/or its casing is
damaged (broken)
- when there are noticeable variations in performance that
cannot be corrected with the normal user controls.
Note: Modify only those parameters shown in the user’s
section of the instruction manual. If parameters or controls
are modified that are not shown in the manual a
realignment of the projector might become necessary and
qualified service personnel might have to be called in.
2.4 Spare parts
Use only original SIM2 Multimedia spare parts
Using components different from the original spare parts
could lead to:
- a deterioration in performance
- fire
- electric shock
- electrical damage
- other
2.5 Cleaning the projector
When we speak about projector cleaning we mean the
outside of it. NO internal cleaning is necessary.
- Before you start cleaning the projector take the plug out
of the mains.
- Do not use liquid or spray detergents.
- Stubborn stains can be removed with a cloth slightly
dampened with a mild detergent solution.
- Never use strong solvents such as thinners, petrol,
acetone or abrasive cleaners as they can damage the
projector’s paint.
Summary of Contents for SVD 800 HD
Page 44: ......
