SVD 800 HD
16
4 INSTALLATION
4.1 Installation procedure
In order to obtain the best performance from the
projector, the following procedure has to be followed
carefully and carried out by a technician.
Note:
The projector is factory-set for front ceiling projection
with a 90” screen, 4/3 format and a projector-screen
distance of 284 cm., see Fig. 49, reference (D),
page 19.
1.
Choose the installation type and read the
instructions through carefully
(see: par. 5.9,
Installation Types, page 32).
Determine the distance between the screen and the
front of the projector.
Determine the projection angle
(see: par. 4.4,
Projection Angle Measurement page 20).
2.
Remove the top and front projector covers
(see:
par. 4.2.1, Removing the cover, page 16).
3.
Insert the correct spacers
(see: par. 4.5.1, Spacer
Changing, page 20).
4.
Prepare and install the screen.
5.
Install the projector on the floor or on the ceiling
and center the screen
(see: par. 4.6, Projector
centering, page 23), maintaining the factory
deflection settings.
6.
Carry out a precise focus adjustment acting on
the lenses.
(see: par. 4.8, Lens Focus Adjustment,
page 23).
7.
If the installation type is the same as the factory
setting, go to step 11, otherwise continue.
8.
Tilt the red and blue tubes until the three crosses
are superimposed.
(see: par. 4.9, Mechanical
centering of the tubes, page 24).
9.
Switch the projector off and disconnect the power
cable.
10. Correct display on the screen
(see par. 4.11, page
24).
11. Put the cover on the video projector.
12. Carry out a fine adjustment of the image with the
remote control.
(see: par. 5, THE RC3000 COM-
PLETE FUNCTIONS REMOTE CONTROL, page
25).
4.2 Removing the cover
4.2.1 Removing the top cover
Loosen the 2 securing screws (A) and lift the cover up.
To remove the top cover completely you must unscrew
the two locking screws (B) close to the two pivots and the
other two (C) securing the jointed rod to the cover.
A
Fig. 40
B
C
Fig. 41
Summary of Contents for SVD 800 HD
Page 44: ......
