SVD 800 HD
26
5.2 Batteries
Handling the remote control and batteries:
- Avoid exposing the remote control to heat and humidity
- When not using the remote control for a long period of
time, remove the batteries.
- Avoid using the RC 3000 remote control with the infrared
control and service light on for a long time as battery
life would then be reduced.
- Do not use new and old batteries together or batteries
of a different voltage or type.
- Handle the remote control with care.
- Use the remote control within its operating range (about
10 metres and a 30
°
angle)
Note:
The RC3000 remote control is powered by four AA
1.5 V batteries and one 9V battery, IEC6F22.
5.4 Turning the projector on
Press the mains switch; the red stand-by LED on the rear
panel turns on.
Press
, or one of the buttons from 1
÷
9.
The red LED becomes green ON.
A white screen appears with the message indicated below.
9 V O L T
4
AA 1.5 V
batteries
RC 3000
BACK OF THE
REMOTE
CONTROL
1
9V battery
IEC6F22
Fig. 63
5.3 How the RC 3000 remote control
works
The following paragraphs describe the functions of the
RC3000 remote control.
Always leave the projector to warm up for ten minutes
after switching it on.
The message disappears temporarily after about 40
seconds after which it reappears for 5 seconds at
approximately 40 second intervals.
Press any key to exit from the initial screen and to see the
picture immediately after having turned the projector on
if, for instance, the adjustment has been completed and
warming up is unnecessary.
WARM-UP time can be modified or excluded,
see par. 3.21
OSD OPTIONS, page 14.
Press
to switch off and then move the power switch
round to OFF.
5.5 Picture adjustment
To change the contrast, brightness, colour, hue and peaking
directly you can use the following buttons:
Press
.
CONTRAST, selects the contrast setting.
Press
or to change the value.
FOR AN OPTIMAL USE THE WHITE
PATTERN WILL REMAIN ON THE
SCREEN FOR 10 MINUTES !
FOR IMMEDIATE USE PRESS ESC
Fig. 64
Fig. 65
Fig. 66
Fig. 67
Press
.
BRIGHTNESS, selects the brightness
setting.
Press or to change the value.
Press
.
COL. selects the colour setting.
Press or to change the value.
CON 80
LUM 50
COL 60
Summary of Contents for SVD 800 HD
Page 44: ......
