![background image](http://html1.mh-extra.com/html/silverline/235896/235896_manual_1273272008.webp)
8
GB
Problem
Possible cause
Solution
Red charging LED does not
illuminate and battery not
charging
Battery not fully seated
Clean battery socket of charger
Charger not powered
Recheck mains connection
Battery pack has low capacity
Battery not being fully charged
Do not remove battery pack until green LED illuminates
Battery charged days before use
Charge the previous day or same day as use
Battery pack has been charged over 100 times and
capacity has started to reduce
This is normal for battery packs. Contact your Silverline dealer to
purchase a replacement battery pack
Drill cannot be switched on
(trigger switch does not move)
The forward/reverse switch may be in the middle
(“locked”) position
Slide the forward/reverse switch either to the left or right
Drill does not start when on/off
trigger switch is depressed
Battery completely discharged
Recharge battery or replace with a fully charged battery
Defective battery
Replace battery
Drill machine defective
Contact your Silverline dealer or authorised service centre
Screws do not reach deep
enough into the workpiece
Not enough torque; torque clutch setting too low
Choose a higher torque setting
Low battery voltage
Recharge battery or replace with a fully charged battery
Screws are driven too deep into
the workpiece surface
Too much torque; torque clutch setting too high
Choose a lower torque setting
Troubleshooting
WARNING:
DO NOT inhale masonry dust. Wear adequate breathing
protection. Dust from masonry, concrete and similar substances is harmful
and may be toxic.
Drilling Wood
• Use rotary drilling mode only
• Ensure that drill bits are suitable for wood, and are within the maximum
capacity of this machine (see “Specifications”)
WARNING:
DO NOT inhale wood dust. Wear adequate breathing protection.
Some wood dusts may be toxic.
Drilling Metal
• Ensure that drill bits are suitable for the grade of metal being drilled, and
are within the maximum capacity of the machine (see “Specifications”)
• To ensure accuracy, mark the intended hole position using a hammer
and centre punch
• Use rotary drill mode only
WARNING:
Never switch the machine to hammer mode when drilling metal.
WARNING:
The drill bit and the workpiece will become very hot when
drilling metal.
DO
NOT touch the bit and never allow it to come into contact
with combustible materials when hot. Always use a suitable lubricant or
cutting fluid, and drill at appropriate speeds.
• Only apply moderate pressure to the drill bit, ensuring efficient cutting
and prolonged drill bit life
• Use a countersink bit to remove sharp burrs from the hole, preventing
cuts and other kinds of injury
Accessories
• A full range of accessories including drill bits, screwdriver bits, wire
brushes etc. is available from your Silverline dealer
Maintenance
WARNING:
Always remove the plug from the mains power supply before
carrying out any maintenance/cleaning of the charger. Remove the battery
before carrying out any maintenance/cleaning of the drill.
Note:
Both the drill and the charger contain no user-serviceable parts.
If the device does not perform as outlined in this manual, return it to an
authorised Silverline service centre for repair.
Cleaning
• Keep your machine clean at all times. Dirt and dust will cause internal
parts to wear quickly, and shorten the machine’s service life. Clean the
body of your machine with a soft brush, or dry cloth. If available, use
clean, dry, compressed air to blow through the ventilation holes
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
Disposal
Always adhere to national regulations when disposing of power tools that
are no longer functional and are not viable for repair.
• Do not dispose of power tools, batteries, or other waste electrical and
electronic equipment (WEEE), with household waste
• Contact your local waste disposal authority for information on the correct
way to dispose of power tools or batteries
235896_Z1MANPRO1.indd 8
19/08/2013 15:17