Silvercrest 101293, Operating Instructions Manual

Page: 132 / 156

128
SAB 160 B2
GB
Device reset (RESET)
To reset the device to its factory default settings, press the
RESET
button
23
with
a pointed object, such as a pen.
NOTE
► To access the
RESET
button, the control panel must be completely removed
(see also Section "Removing the control panel").
► If a reset does not correct the fault, please contact our Service department
(contact information see guarantee card).
Reset the device:
▯ when using it for the fi rst time,
▯ after connecting the cables,
▯ if not all function buttons are working,
▯ if an error message is shown on the display,
▯ if there is an obvious malfunction in the device.
Settings
WARNING
Excessive volume can cause hearing damage!
Setting the volume too high can result in permanent hearing damage.
► Set the volume to moderate levels only.
Volume
♦ Turn the multi-controller 3 to set the volume.
Loudness
♦ Hold down the
MD/LD
button
5
to switch the loudness function on or off .
LOUD ON
or
LOUD OFF
appears on the display.
Switching mute on and off
♦
P
ress the / button
19
to switch the sound off . "
MUTE
" fl ashes on the
display.
♦ Press the / button again to turn the sound on again. Muting is can-
celled when receiving a PTY or TA station or if you change station or source.
IB_101293_SAB160B2_LB1.indb 128 07.07.14 14:49