74
Chapter 5: Maintaining Disk Modules
6.
Touch the new disk module’s antistatic packaging to discharge it and
the drive module. Remove the new disk module from its packaging.
7.
On the label on the side of the disk module, write the ID number for the
compartment into which the drive is going. You can either write the slot
position on the label in the corresponding place on the matrix or make a
check mark in the position to indicate the slot that the disk module
occupies. Figure 5-10 shows these two ways of labeling disk module
A0.
Figure 5-10
Marking the Label for Disk Module A0
For reference, Figure 5-11 diagrams all disk module locations.
RACK
TOWER
RACK
TOWER
A0
or
For deskside chassis
RACK
T
OWER
RACK
T
OWER
A0
or
For chassis assembly in rack
