Silex technology BR-310AC, User Manual

Page: 105 / 108

A. Appendix
99
A-2. Troubleshooting
This section provides the solutions for possible troubles you may experience when you are
configuring or using the BR-310AC.
My Access Point is not displayed in the Wireless Network List of the Web configuration interface.
The Access Point may not be active.
Solution Please check that the Access Point is operating correctly.
The Access Point may be operating in a stealth mode.
Solution Configure the detailed settings of the wireless network at
Detailed Configuration
of the Web configuration interface to connect to the Access Point. Remember that
Access Points operating in a stealth mode will not be displayed in the list.
Too many wireless devices may be operating, exceeding the maximum number of
devices the BR-310AC can show on (up to 32 devices).
Solution Up to 32 wireless devices can be displayed at
Wireless Network List
.
To show your Access Point in the list, use
SSID Filter
so that only the specified
networks are displayed there.
Even when the Access Point is not displayed in the list, it can be connected
by configuring the wireless settings at
Detailed Configuration
of the Web
configuration interface.
I failed to connect to a wireless network using Smart Wireless Setup.
The WPS feature may be disabled on the Access Point.
Solution
Check that the Access Point supports the WPS feature.
Depending on the Access Point, you may need to manually enable the WPS
feature. For details, see the operating manual that came with your Access Point.
The SSID Filter may be enabled on the BR-310AC.
Solution
Disable the
SSID Filter
at
Detailed Configuration
of the Web configuration
interface. If the
SSID Filter
is enabled, configuration using Smart Wireless Setup
does not work.