Operating manual - English
REKORD
Copyright Silca 2 007
21
8.2
Replacing the brush
When the brush no longer cleans off the burrs it must be replaced as follows:
ATTENTION: remove the mains plug.
1) Place the locking rod (provided) in position on the motor shaft.
2) Use the Allen wrench (provided) to loosen the screw holding the brush in place (fig. 19).
3) Replace the brush and tighten the screw with the Allen wrench.
4) Remove the spanner from the motor shaft.
Fig. 19
8.3
Replacing and/or tightening the belt
Worn or loose belts (T) must be replaced or adjusted so as to ensure safe and proper operation of the
cutting tool/ brush.
Tension:
ATTENTION: remove the mains plug.
1) Remove the two protective pads (Q) (fig.4, page
6).
2) Loosen the 3 screws (M1) and remove the top
cover (M).
3) Loosen the 4 screws (S1) of the plate motor (fig.
22).
4)
Push the motor down until the proper belt ten-
sion is obtained.
5) Tighten the four screws.
Fig. 20
Replacement:
ATTENTION: remove the mains plug.
1) Remove the two protective pads (Q).
2) Loosen the 3 screws (M1) and remove the top
cover (M).
3) Remove the brush (fig. 19).
4) Remove the 3 screw (M2) (fig. 19) to remove the
protective cover (fig. 22)
5)
Loosen the 4 screws (S1) of the plate motor (fig.
22)
6) Raise the motor and remove the worn belt.
7) Fit the new belt.
8)
Replace the motor in its previous position.
9) Tighten the 4 screws.
10) Replace the belt cover
11) Replace the brush
12) Replace the top cover
Fig. 21
locking
brush holding
rod
screw
loosen
tighten
M1
M2
