Operating manual - English
REKORD
Copyright Silca 2 007
11
5
MACHINE INSTALLATION AND PREPARATION
The REKORD key-cutting machine can be installed by the purchaser and does not require any special
skills.
However, some checks and preparation for use need to be carried out by the operator.
5.1
Checking for damage
The REKORD key-cutting machine is solid and compact and will not normally damage if transport,
unpacking and installation have all been carried out according to the instructions in this manual.
However, it is always advisable to check that the machine has not suffered any damage.
5.2
Environmental conditions
To ensure that the best use is made of the REKORD key-cutting machine, certain parameters must be
borne in mind:
- damp, badly ventilated sites should be avoided.
- The ideal conditions for the machine are:
- temperature:
from
0
to
40°C
- relative humidity:
approx. 6
0%
5.3
Positioning
Place the key-cutting machine on a horizontal surface, solid enough to take the weight (19 Kg).
To facilitate operation and maintenance, install the machine with a space of at least 200 mm on all sides
(fig. 6).
Ensure that the machine stands pe rfectly balanced on the four fee t. Vibration is avoided when the
machine is properly set on the horizontal plane.
ATTENTION: ensure that the machine voltage is the same as that of the mains, which must be properly
earthed and provided with a differential switch.
Fig. 6
200 mm
200 mm
200 mm
