Operating manual - English
REKORD
Copyright Silca 2 007
23
8.5
Regulating carriage depth
The carriage on the REKORD can be regulated to protect the clamps from coming into contact with the
tracer point or cutting tool.
ATTENTION: the play between cutting tool/tracer point and clamps must be 0.1 mm.
Should it be different from this, proceed as follows:
ATTENTION: remove the mains plug.
1) Release the carriage, raise against the cutting tool and take to the end of its run (fig. 26).
2) Remove the chippings tray (C) and tool holder (C1).
3) Release the nut with the spanner (fig. 26).
4) Use the Allen wrench to screw or unscrew the grub screw in order to move the carriage away from
or towards the tracer point and cutting tool.
5) Tighten the nut.
Fig. 26
8.6
Replacing the fuses
ATTENTION: remove the mains plug.
1) Unplug the power cable from the key-cutting machine socket.
2) Turn the key-cutting machine round so as to reach the fuse housing on the back.
3) Remove the fuses box placed below the key-cutting machine socket (V) (fig. 27).
4) Replace the fuses (U) (fig. 27).
5) Close the fuses box and connect the power cable.
ATTENTION: fuses must always be replaced with others of the same type (rapid) and with the same Amps (4
Amps for 230V; 8 Amps for 120V.
Fig. 27
allen
wrench
0,1 mm
spanner
fuse box
U
