Operating manual - English
REKORD
Copyright Silca 2 007
25
8.9
Replacing motor/condenser
Motor
ATTENTION: remove the mains plug.
1) Remove the two protective pads (Q).
2) Loosen the 3 screws (M1) and remove the top cover
(M).
3) Detach the 4 co nnectors (S2 ) from the mo tor o n
switch.
4) Loosen the 4 screws (S1) ( fig. 22 ) on the motor
fixing plate and remove the belt.
5) Loosen completely only the 2 lower screws (S1) the
motor fixing plate and pull downwards.
Fig. 30
Condenser
ATTENTION: remove the mains plug.
- Access the bottom part (see ch. 8.7)
- R
e
move the motor (see ch. 8.9 - Replacing motor)
- Loosen the nut (Z) (fig. 32) and remove together with
the washer.
- Loosen the 4 screws (S4) on the motor box and re-
move.
- Loosen the 2 condenser connection screws (X1).
- Loosen the nut on the wire grommet (X) and remove
the condenser.
- Fit the new conden ser, taking the wire through the
nut (X) replace the motor box and secure with the 4
screws (X1).
- Tighten the grommet nut (X), replace the motor box
and secure with the 4 screws (S4).
- Replace the condenser (see points 9 to 13).
-
Loosen the 4 screws (S3) on the motor fixing plate
.
- Secure the new motor on the fi xing plate with the
screw (S3).
- Replace the motor.
Fig. 31
6) Place the machine in position on the work bench.
7) Install the belt and tighten the 4 screws (S1) (fig. 22) of the plate motor.
8) Connect the 4 connectors (S2) (fig. 30) to the motor on switch and fit the earth wire to its screw with
the nut (S5) (fig. 34).
9) Replace the condenser and secure with washer and nut.
10) Replace the bottom grate and secure with the screws (Y) (fig. 28).
11) Place the machine in position on the work bench.
12) Replace the top cover and secure with the 3 screws (M1).
13) Replace the protective pads (Q).
Fig. 32
Fig. 33
S2
S3
Z
X
X1
S4
