9.18 Replacing and/or tightening the belt
ATTENTION: turn off the machine and unplug.
1) Remove the top mat.
2) Loosen the 4 screws (S2), remove the 2 screws (S3) and remove the top cover (S1) (Fig.79).
3) Gain access to the bottom compartment (chap.9.6).
• To
TIGHTEN:
4) Loosen the 4 nuts (H1) (Fig.83), push the motor towards the back of the machine and then tighten the 4 nuts
(H1).
• To
REPLACE:
5) Loosen the 4 nuts (H1) and move the motor forward towards the machine .
6) Loosen the 3 screws (S4) and remove the Plexiglas shield (Fig.80).
7) Remove the brush (chap.9.4).
8) Loosen the 3 screws (H6) and remove the belt protection (H7) (Fig.84).
9) Remove the belt (H8) and fi t a new belt into the two pulleys (Fig.85).
10) Replace the belt protection (H7) and secure with the screws (H6).
11) Replace the brush.
12) Re-fi t the Plexiglas shield.
13) Push the motor towards the back of the machine and tighten the 4 nuts (H1).
14) Place the bottom cover (X) in position, secure with the screws (X1) and screw in the 4 feet (V1) (Fig.65).
15) Place the machine upright on the worktop and insert the swarf tray (V).
16) Secure the top cover with the screws (S2) and (S3) (Fig.79); replace the mat.
Fig.83
Operating Manual
OMNIA / OMNIA 650rpm / OMNIA MAX / OMNIA W MAX
Copyright Silca 2014
48
