9.9 Replacing the reset switch
ATTENTION: turn off the machine and unplug.
1) Gain access to the bottom compartment (chap.9.6).
2) Loosen the ring nut (A3) and remove the motor start button (B) (Fig.68).
3) Disconnect the 4 connectors (A4) on the switch, observing their position carefully (Fig.69).
4) Press
the
fi xing tabs on the switch so that it can be pulled out towards the operator. Observe its position carefully.
5) Fit the new switch, taking care to position it properly.
6) Re-connect the 4 connectors (A4).
7) Place the bottom cover (X) in position, secure with the screws (X1) and screw in the 4 feet (V1) (Fig.65).
8) Place the machine upright on the worktop and insert the swarf tray (V).
Fig.69
9.10 Replacing the microswitch
ATTENTION: turn off the machine and unplug.
1) Gain access to the bottom compartment (chap.9.6).
2) Disconnect the 3 connectors (c) (nc) (no) (Fig.70).
3) Loosen the 2 support plate screws (P3) and remove.
4) Loosen the 2 screws (R3) and 2 nuts (R4) so that the microswitch can be removed (Fig.71).
5) Attach the new microswitch to the plate with the 2 screws (R3) and nuts (R4).
6) Replace the plate and secure with the 2 screws (P3). When the carriage is idle (fully back towards the operator)
the microswitch lever must be down.
7) Place the bottom cover (X) in position, secure with the screws (X1) and screw in the 4 feet (V1) (Fig.65).
8) Place the machine upright on the worktop and insert the swarf tray (V).
Operating Manual
OMNIA / OMNIA 650rpm / OMNIA MAX / OMNIA W MAX
Copyright Silca 2014
42
