8.5 Cutting pump keys
1) Use the lever (Q) to lock the right-hand clamp in the horizontal position.
2) Fit the original key into the left-hand clamp (M) with the bit up against the lower jaw of
the clamp (Fig.55).
3) Use the special seats for pump keys: for keys with round shafts and Mottura type keys
with square shafts (Fig.54).
4) Fit the key blank into the right-hand clamp (M1) in the same way.
NOTE: we recommend using the tracer point spring function (chap.7.2).
5) Turn on the machine with the ON/OFF switch.
6) Use the lever (L) to slowly take the carriage towards the cutter and press the button
(B) to start the motor.
7) Take
the
fi rst cut on the right of the original key against the tracer point and push the
carriage all the way.
8) Take the carriage back to come out of the cut. Move the carriage sideways and enter the next cut. Do not move
sideways once into the cut.
9) Complete all the bits in the same way and if necessary check the sides of the bits.
10) When the cutting operation is fi nished, take the carriage all the way back (the motor will stop automatically) and
remove the keys.
Fig.54
Fig.55
Operating Manual
OMNIA / OMNIA 650rpm / OMNIA MAX / OMNIA W MAX
Copyright Silca 2014
36
