9.3 Replacing the cutter
ATTENTION: turn off the machine and unplug.
1) Remove the carriage (chap.5.6).
2) Slot the locking rod (provided) into the hole of the cutter shaft (Fig.60 and Fig.61).
3) Use the spanner provided to loosen the cutter locking nut.
ATTENTION: the thread is left-handed.
1) Remove the worn cutter.
2) Carefully clean the new cutter and its seat.
3) Install the new cutting tool and tighten the nut.
ATTENTION: the tool rotates clockwise.
4) Remove the locking rod.
5) Re-position the carriage and check depth calibration as described in chap.7.5.3.
Fig.60 Fig.61
9.4
Replacing the brush
ATTENTION: turn off the machine and unplug.
1) Remove or move the carriage (chap.5.6).
2) Slot the locking rod (provided) into the hole of the cutting
tool shaft (Fig.60).
3) Use the Allen key to loosen the screw (U2) and remove
the brush (Fig. 62).
4) Replace the brush and tighten the screw (U2) with the
Allen key.
Fig. 62
Operating Manual
OMNIA / OMNIA 650rpm / OMNIA MAX / OMNIA W MAX
Copyright Silca 2014
39
