Sigalarm WCM4.0, Installation And Operation Manual

Page: 31 / 36

31
SIGALARM INSTALLATION AND OPERATION MANUAL / GENERATION 4 WIRELESS
7. SPECIFICATIONS
7.1 DIMENSIONS
Control Module W 7.5 D 3.0 H 5.25
Sensor W 4.5 D 2.5 H 1.5
External Speaker W 5 D 5 H 5
Cables 30 Ft
7.2 MATERIAL
Control Module ABS plastic enclosure
Sensor Enclosure Built with ABS plastic
External Speaker ABS with stainless steel hardware
Cables 18 AWG stranded tinned copper conductors with PVC
insulation, water blocking tape, foil shield and PVC
jacket
7.3 POWER SUPPLY REQUIREMENTS
12-48 Volt
7.4 E-FIELD DETECTION
Electric Field 60 Hz or 50Hz
**selector switch located on board** default is 60Hz
7.5 RANGE OF EFFECTIVENESS
Voltage Detection – Between 10 to 200 feet depending on voltage
Zigbee Communication – 27 meters (Between sensors and control module)
7.6 SENSOR BATTERY
Each sensor is equipped with a lithium polymer battery that should last
approximately 660 hours with no sunlight. Variables such as extreme heat or
cold will affect estimated battery life. The solar panels will continually charge
this battery for years. Completely dead batteries will take approximately 24
hours to charge (at approximately 100 milliamps per hour). If the battery is
allowed to run down to 3.0 volts or less the sensor will enter self-preservation
mode and shut down. The sensor will resume operations at 3.2 volts and, is
considered fully charged at 3.75 volts.
The sensor battery can be charged using any micro USB. Plug the USB in the (J1)
port. The switch must be in the on position to charge the battery.