SIGALARM INSTALLATION AND OPERATION MANUAL /
GENERATION 4 WIRELESS
26
SET POINT
The operator must decide what set point is appropriate for each and every
jobsite
5.1 WARNINGS
The operator must fully understand how the Sigalarm system functions, and its
limitations before use. It is dangerous to operate any equipment directly beneath
or above high voltage power lines. Never approach any power line closer than the
minimum safe distance set by OSHA. If multiple lines are present the Sigalarm
system should be set to the lowest voltage line, and additional precautions may
be required.
5.2 OPERATING PROCEDURE
Powering up: When power is first applied the control module will search for
sensors. No data will appear while connectivity is in progress (approx. 2 seconds).
Once sensors are connected the control module will go into a maximum setting. If
any power lines are in the vicinity the alarms will sound. The operator must select
the reset button to revert the system to the last displayed set point.
The operator must decide what set point is appropriate for each and every jobsite.
To adjust the set point, position the equipment at the desired location where the
operator would like an alarm state, then depress the “one touch” button. This will
change the set point to the greatest numerical sensor r5 at that position.
When adjusting the set point, always position the equipment far enough away
from the power line to give the operator time to react.
5. OPERATION
!
IF MULTIPLE LINES ARE PRESENT THE SIGALARM SYSTEM
SHOULD BE SET TO THE LOWEST VOLTAGE LINE, AND
ADDITIONAL PRECAUTIONS MAY BE REQUIRED.
Summary of Contents for WCM4.0
Page 2: ......
Page 3: ...PAY WITH PURCHASEORDER NOWAVAILABLEAT SIGALARMINC COM SHOP...
Page 35: ......