9
SIGALARM INSTALLATION AND OPERATION MANUAL /
GENERATION 4 WIRELESS
2.5 INSTALLATION OF THE SENSOR(S); SIGALARM WS4.0
The solar sensors are the component of the system that detects voltage.
TURN THE SENSOR ON:
Remove the sensor lid and put the switch (sw1) in the on position. Prior to operation
connect the solar panel in the lid to the (J3) connector in the base of the sensor.
Close the sensor insuring the solar panel cables are not caught between the seal.
Loosely assemble screws in the sequence shown below
Tighten all screws to an 8 inch-pound torque. There may appear to be a gap
between the lid and the base. This is normal. Over-tightening of screws to close the
gap is not recommended.
1
4
2
3
60 HZ OR 50 HZ
Sensors are shipped with a factory setting to detect 60Hz. Upon request
50Hz presets can be made prior to shipping. Customer may also switch
between 60 Hz to 50 Hz by utilizing the switch (sw2) on the sensor.
Summary of Contents for WCM4.0
Page 2: ......
Page 3: ...PAY WITH PURCHASEORDER NOWAVAILABLEAT SIGALARMINC COM SHOP...
Page 35: ......