Sierra Wireless MP 700 Series, Command Reference Manual

Page: 57 / 118

Command Reference
Rev 3.2 Oct.05 55
!MPPDDELAY=
<value>
!MPPDDELAY?
[<querytype>]
Set power down timer
Sets the length of a timer that begins counting down when the power is removed
or the ignition sense wire is pulled low. (See
!MPIGNSENSE .) The
MP 700 Series GPS powers down when the timer expires.
The <value> is in minutes (minimum 0, maximum 240). (The default is 0.)
Depending on the <querytype> , !MPPDDELAY? returns:
•
<querytype>=0
Length of the timer (default)
•
<querytype>=1
Time remaining before expiry
!MPPRIVIP=
<IP addr>, <local port>,
<host port>
!MPPRIVIP?
Set the private IP address
The private IP is used for data traffic between the MP and Watcher, to
distinguish control and status messages from network traffic.
Any valid private IP address can be used. Using a pubic IP address could cause
the application to fail.
Parameter settings
The parameters are:
•
<IP addr>
The IP address used between Watcher and the
MP 700 Series GPS (not used for network traffic).
•
<local port>
Number of the port on which the MP 700 Series GPS receives
control and status messages
•
<host port>
Number of the port to which the MP 700 Series GPS sends
control and status data
!MPPRIVIP? returns the current private IP address. The default is 10.0.0.1
!MPSETDFLT=
<value> Set the default GPRS profile
The MP 700 Series GPS allows for three profiles. This sets which is the default:
•
<value>=1
Profile 1 is the default
•
<value>=2
Profile 2 is the default
•
<value>=3
Profile 3 is the default
As shipped, the default profile is Profile 1. The default profile is the one used to
establish a GPRS connection unless the user explicitly selects a different
profile.
Table 3-9: Command Reference Table (ASCII Alphabetic)
Command Description