Sierra Wireless MP 700 Series, Command Reference Manual

Page: 11 / 118

About This Guide
Document Structure
Following this introduction is a section on basic elements
important to understanding and communicating with the
MP 700 Series GPS. This includes notes on the connection
between the host computer and the modem.
The document then presents the commands, registers, result
codes, and defaults provided in the command state of the
modem.
Commands are often termed AT commands . Hayes™ origi­
nated the convention of prefixing commands with an
“ATtention” string for wireline modems.
In addition to the commands, this document also describes the
definitions and use of status registers.
Commands are referenced in strict alphabetical order. This
facilitates searches for the syntax, parameters, and operation of
specific commands. To help locate whether or not a command
exists to perform a desired function, there are tables
organizing the commands into groups.
Descriptions of the definitions and use of status registers, as
well as a table of the factory/reset defaults, follow, along with
result codes, both numeric and verbose.
Conventions
The following format conventions are used in this reference:
• Character codes or keystrokes which are described with
words or standard abbreviations are shown within angle
brackets using a different font: such as
<CR>
for Carriage
Return and
<space>
for a blank space (spacebar) character.
• Numeric values are decimal unless prefixed as noted
below.
• Hexadecimal values are shown with a prefix of 0x, i.e. in
the form 0x3D.
• Binary values are shown with a prefix of 0b, i.e. in the form
0b00111101.
• Command and register syntax is noted using an alternate
font:
ATD6045559010
.
Note: The
AT
characters must be included before all commands,
except as noted in the reference tables.
Rev 3.2 Oct.05 9