Sierra Wireless MP 700 Series, Command Reference Manual

Page: 12 / 118

MP 700 Series GPS AT Command Reference
• Characters that are required are shown in uppercase;
parameters are noted in lowercase. Parameters are
enclosed in angle brackets (
<i>
) to indicate that they should
be replaced with a value. Optional parameters are
described in the text, and may also be enclosed in square
brackets (
[<m>]
) for clarity.
• Supported parameter values (either set or returned) are
described in the text.
Note: The brackets shown with parameters are not to be included in
the command string.
The default settings are noted in the command tables. Note
that these are the factory default settings and
not the default
parameter value assumed if no parameter is specified. The
factory defaults are also noted in a section at the end of the
Commands chapter, on page 107.
Result Code This is a numeric or text code that is returned
after all commands (except resets). Only one result code is
returned for a command line regardless of the number of
individual commands contained on the line.
Response This term indicates a response from the modem
that is issued prior to a result code. Reading registers or
issuing commands that report information will provide a
response followed by a result code unless the command
generates an error.
See page 20 for a discussion of how the modem frames these
two elements.
In this document, responses and result codes from the modem,
or host system software prompts, are shown in this font:
CONNECT 14400
OK
10 2130309