Sierra Wireless MP 700 Series, Command Reference Manual

Page: 53 / 118

Command Reference
Rev 3.2 Oct.05 51
!MPMTCONF
(continued)
!MPMTCONF?
<n>
Configure MT protocol (continued)
Parameter settings
The supported values are:
•
Reporting engine
<engid>=
0 Engine 0
1 Engine 1
2 Engine 2
3 Engine 3
•
Connection type
<ctype>=
0 Engine is unused
1 MTP embedded in UDP packets
2 Unused
3) Raw GPS data embedded in UDP packets
Setting <ctype> to 0 disables the engine.
•
Destination address
<destip>=
IP address (in the form, nnn.nnn.nnn.nnn) of the destination device.
•
Destination port number
<destport>=
1 - 65535
•
Low rate timer <lowtmr>=
0 Disabled
1-255 Interval between reports in minutes (5 by default.)
•
Fast rate timer <fasttmr>=
0 Disabled
2-30 Interval between reports in seconds (3 by default.)
•
GPS timer <gpstmr>=
0 Disabled
1-255 Interval between reports in seconds (10 by default.)
When the GPS timer is disabled, the module continues to send unsolicited reports.
!MPMTCONF?<n> returns the configuration settings for the engine as specified
by <n> (where <n> is 0, 1, 2, or 3)
!MPNVDEF Set modem configuration parameters to defaults
Resets parameters stored in non-volative memory to defaults. This includes
configuration settings for GPS, I/O, MTP, Fallback, Connection Watchdog,
Operating Mode, PAD, and USB.
Table 3-9: Command Reference Table (ASCII Alphabetic)
Command Description