SIT SITRANS RD300RANS RD300
Page 20
SITRANS RD300 – OPERATING INSTRUCTIONS
A5E31917845
Display
Parameter
Action/Setting Description
Lt-CLr
Latching-
cleared
Set relay for latching operation with
manual reset only after alarm condition
has cleared (relays assigned to rate)
Altern
Alternate
Set relay for pump alternation control
(relays assigned to rate)
Sanmpl
Sampling
Set relay for sampling operation
OFF
Off
Disable relay and front panel status LED
(Select Off to enable Interlock feature)
Set 1
Set 1
Program set point 1
RSt 1
Reset 1
Program reset point 1
RLY 2
Relay 2
Relays 2-8 setup
Note: Relays 5-8 are shown, only if
expansion relay module is installed.
FaiLSF
Fail-safe
Enter
Fail-safe
menu
FLS 1
Fail-safe 1
Set relay 1 fail-safe operation
on
On
Enable fail-safe operation
off
Fail-safe off
Disable fail-safe operation
DeLAY
Delay
Enter relay
Time Delay
menu
DLY 1
Delay 1
Enter relay 1 time delay setup
On 1
On
Set relay 1 On time delay
OFF 1
Off
Set relay 1 Off time delay
break
Loop break
Set relay condition if loop break detected
(For mA input only)
iGnorE
Ignore
Ignore loop break condition
(Processed as a low signal condition)
On
On
Relay goes to alarm condition when loop
break is detected
OFF
Off
Relay goes to non-alarm condition when
loop break is detected
Aout
Analog output
Enter the
Analog output
scaling menu
Dis 1
Display 1
Program display 1 value
Out 1
Output 1
Program output 1 value (e.g. 4.000 mA)