Siemens SINAMICS G110, Operating Instructions Manual

Page: 20 / 92

Installation 04/2005
SINAMICS G110 Operating Instructions
20
6SL3298-0AA11-0BP0
2.8 Mechanical Installation
WARNING
¾
To ensure the safe operation of the equipment, it must be installed and
commissioned by qualified personnel in full compliance with the warnings laid
down in these operating instructions.
¾
Take particular note of the general and regional installation and safety
regulations regarding work on dangerous voltage installations (e.g. EN 50178),
as well as the relevant regulations regarding the correct use of tools and
personal protective equipment (PPE).
¾
Never use high voltage insulation test equipment on cables connected to the
inverter.
¾
The mains input, DC and motor terminals, can carry dangerous voltages even if
the inverter is inoperative; wait 5 minutes to allow the unit to discharge after
switching off before carrying out any installation work.
CAUTION
The control, power supply and motor leads must be laid separately. Do not feed
them through the same cable conduit/trunking.
Table 2-1 Dimensions of the SINAMICS G110 Inverter
Overall Dimensions Drilling Dimensions
Frame Size Output
H
mm
(inches)
W
mm
(inches)
D
mm
(inches)
Depth with
BOP fitted
mm
(inches)
H1
mm
(inches)
W2
mm
(inches)
A 120 W
150
(5.91)
90
(3.54)
116
(4.57)
124
(4.88)
140
(5.51)
79
(3.11)
A 250 W
150
(5.91)
90
(3.54)
116
(4.57)
124
(4.88)
140
(5.51)
79
(3.11)
A 370 W
150
(5.91)
90
(3.54)
116
(4.57)
124
(4.88)
140
(5.51)
79
(3.11)
A 550 W
150
(5.91)
90
(3.54)
131
(5.16)
139
(5.47)
140
(5.51)
79
(3.11)
A 750 W
150
(5.91)
90
(3.54)
131
(5.16)
139
(5.47)
140
(5.51)
79
(3.11)
A
(Flat Plate)
120 W – 750 W
150
(5.91)
90
(3.54)
101
(4.01)
109
(4.29)
140
(5.51)
79
(3.11)
B 1.1 kW
160
(6.30)
140
(5.51)
142
(5.59)
150
(5.90)
135
(5.31)
127
(5.0)
B 1.5 kW
160
(6.30)
140
(5.51)
142
(5.59)
150
(5.90)
135
(5.31)
127
(5.0)
C 2.2 kW
181
(7.13)
184
(7.24)
152
(5.98)
160
(6.29)
140
(5.51)
170
(6.70)
C 3.0 kW
181
(7.13)
184
(7.24)
152
(5.98)
160
(6.29)
140
(5.51)
170
(6.70)