Siemens SIMATIC MV420, Operating Instructions Manual

Page: 338 / 424

Alarm, fault and system messages
11.2 Reporting diagnostics information
SIMATIC MV420 / SIMATIC MV440
336
Operating Instructions, 04/2013, A5E02371045-06
Message Value
(onboard
PROFINET
diagnostics) Value
(TCP/IP and
RS232) Value
(FB45,
error_MOBY) Value
(Ident
profile,
STATUS
byte)
(byte 0,
byte 1,
byte 2) Description How to remedy the
problem
Error - transfer
error ASM/
PROFINET IO
W#16#5007 07 0A E1, FE, 04 The send buffer is
full because the
data cannot be
queried in an
adequately short
time.
Reduce the trigger
frequency or process the
results more quickly on
the CPU. If necessary,
the baud rate on the
ASM connection can
also be increased
To cover short peaks,
the image buffer size of
the program under
Image acquisition,
"Control" tab can be
increased.
Error saving
code
W#16#500A 10 02 E6, FE, 04 No code was found
in the image during
program saving.
Position the code within
the image or improve the
image quality.
Error - match
error
W#16#500B 11 0E E1, FE, 07 The saved code
cannot be
processed with the
match settings (for
example
ID/separator not
found)
Adapt the match
settings, or save a
suitable code.
Error
No ECC 200
code
W#16#500C 12 02 E6, FE, 04 The code found
during saving does
not comply with the
ECC 200 standard.
Note:
Applies only to the
ID-Genius decoder.
Use a code conforming
to the standard or
change to the standard
decoder.
Error
TCP
communication
W#16#500E 14 0C E1, FE, 01 Connection error in
communication
over a TCP
connection or when
using an Ethernet
RS232 converter:
There is no TCP
connection or the
data transfer
cannot be
completed within
the set time limit.
Make sure that the
connected TCP partner
is correctly configured
and ready to receive.